Emu oil in soap making
Published by The Soap Brain Team
Emu oil is a conditioning soap-making oil rich in oleic acid (45%). A gram of it turns to soap with about 0.138 g of NaOH (lye). It makes a mild, gentle bar and pairs well with a harder, cleansing oil. Most soapers use it at 0–13% of their oils.
Fatty-acid profile
Emu oil is a gentle, conditioning oil, mostly unsaturated fatty acids that leave a mild, moisturising bar with a softer, lower lather. It pairs naturally with a harder, more cleansing oil to firm the bar up and add bubbles. Because its polyunsaturated (linoleic/linolenic) share is on the higher side, watch the total across the whole recipe and consider a modest antioxidant to guard against rancidity and DOS.
Emu oil is about 30% saturated fat and 60% unsaturated — that unsaturated majority is what makes it conditioning and slower to trace, but softer on its own.
| Fatty acid | Share | What it does in soap |
|---|---|---|
| Oleic acid | 45% | a monounsaturated fatty acid that makes a gentle, conditioning, moisturising bar with a slick, lower lather and a slower trace |
| Palmitic acid | 22% | a saturated fatty acid that builds a hard, long-lasting bar with a stable, creamy lather |
| Linoleic acid | 15% | a polyunsaturated fatty acid that is very conditioning but oxidises readily — a driver of DOS (dreaded orange spots) at high levels |
| Stearic acid | 8% | a saturated fatty acid that adds hardness and a thick, stable lather; a large share can speed up trace |
Emu oil in the bar
Expect a dense, low-bubble, creamy lather from Emu oil — rich and steady rather than foamy. Pairing it with a bubbly oil adds the fluffy bubbles it lacks.
Emu oil traces at a fairly typical pace; how fast the whole batch moves will depend mostly on the other oils, your temperatures and any fragrance you add.
In a blend Emu oil is the conditioning, skin-feel component and can often make up the bulk of the oils. Add a firmer, more cleansing oil — coconut, palm or a hard butter — to bring hardness and bubbles the finished bar would otherwise miss.
Closest substitutes for Emu oil
Out of Emu oil? These oils behave most like it in a bar — ranked by how close their hardness, cleansing and conditioning profile and lye (SAP) requirement are. The numbers are predicted properties for a 100% single-oil bar, not a safety guide; always recalculate the lye when you swap an oil.
| Oil | Hardness | Cleansing | Conditioning | SAP (NaOH) |
|---|---|---|---|---|
| Emu oil (this oil) | 30 | 0 | 60 | 0.138 |
| Neem oil | 38 | 0 | 60 | 0.139 |
| Tamanu (foraha) oil | 30 | 0 | 68 | 0.139 |
| Cottonseed oil | 26 | 1 | 69 | 0.137 |
| Baobab oil (refined) | 24 | 0 | 70 | 0.135 |
Using Emu oil in a recipe
One gram of Emu oil needs about 0.138 g of NaOH (sodium hydroxide) to turn fully to soap, within a documented range of 0.132–0.147 g/g across sources. The calculator below uses this value; always confirm the lye weight before you mix.
Its iodine value is about 68 — a moderate value, a good all-round balance of hardness and conditioning. Iodine value is only a rough guide, not a hard rule, but it gives you a feel for how a bar built around this oil will wear.
Most soapers use Emu oil at roughly 0–13% of their oils.
Maker's note: Animal fat (NOT vegan) with a lard/tallow-like feel; makes a mild, conditioning bar.
Calculate lye for Emu oil
The calculator below is pre-loaded with Emu oil. Enter your weights, add other oils, and it works out the exact NaOH (lye) weight, water and quality numbers. Always weigh lye, oils and water — never measure by volume, wear gloves and eye protection, and add lye to water (never the reverse).
Loading the calculator…
Where these numbers come from
Every figure on this page is backed by at least two independent references, listed below — so you can check our work instead of taking our word for it.
- The Soap Kitchen — SAP chart — SAP NaOH 0.135
- Alfa Chemistry — saponification reference — SAP NaOH 135.9 / KOH 190.26 mg/g
- ResearchGate — Emu oil characterization (India) — SAP 195–220 (lab)
- Lan et al. (2022), Nutrients 14(11):2238 — Chemical characterization of emu oil — peer-reviewed GC profile: palmitic 25.67, stearic 9.06, oleic 45.76, linoleic 14.00, palmitoleic 4.08; iodine 72.67 (corroborates the stored profile within emu's dietary variation)
SAP data last updated · 51 oils covered.
Emu oil soap FAQ
- Can you make soap with 100% Emu oil?
- It is not recommended. Emu oil shows its best in a blend, usually up to about 13% of the oils. On its own the bar would be unbalanced — too soft or low-lathering for everyday use.
- What superfat should I use with Emu oil?
- A 5% superfat is a safe, common starting point for recipes using Emu oil; adjust to taste once you know how the finished bar feels. Never drop to 0% or below without a deliberate reason — the calculator will ask you to confirm it.
- Does Emu oil speed up or slow down trace?
- Emu oil traces at a fairly typical pace; how fast the whole batch moves will depend mostly on the other oils, your temperatures and any fragrance you add.